Low-Cost Unitized System Available in U.S.

Unitized hot-runner manifold systems, which don’t require assembly before mounting between retainer plates, are a new offering in North America from PSG Plastic Service Group Inc., Stevensville, Mich. The German-based firm has offered the system in Europe. Unitized systems eliminate the need for support plates, cost less than bolt-on hot-half systems, and allow for the removal of the clamp plate without heating the manifold system. PSG offers the system fully assembled and pre-wired in a wide variety of nozzle, manifold, and cylinder configurations, with sliding seal, screw-in nozzles, or single valve gates.

Link to this article:Low-Cost Unitized System Available in U.S.

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks

Bookmark the permalink.

Comments are closed.