What effect does the setting of the high speed fiber laser cutting machine have on the cutting processing effect

Compared with other traditional cutting methods, the 750w fiber laser Cutting Machine has obvious advantages-narrow slits, small workpiece deformation, and fast cutting speed, high efficiency, low cost, safe operation and stable performance. But when using machine fiber Laser Cutting 1500w, we must pay attention to the setting of processing parameters, in order to achieve a better cutting processing effect. Otherwise, the impact will be great. LXSHOW will come to you today to talk about the effect of 3015 1000w fiber laser cutting machine settings on the cutting processing effect.1. When the laser cutting speed is too fast, it will cause the following undesirable results:

  • ①Causes the entire section to be thicker, but no melting stains occur;
  • ②Unable to cut, sparks spray randomly;
  • ③The oblique stripe path appears on the cutting surface, and the lower part of the melting spot is generated.

2. On the contrary, when the laser cutting speed is too slow, it will cause:

  • ①The over-melting condition is caused, and the cutting surface is rough.
  • ②The slit is widened and melted at the sharp corner.
  • ③Affect the cutting efficiency.

Therefore, in order to make the fiber laser 500 watt cutting machine play its cutting function better, it can be judged from the laser equipment to cut the spark to determine whether the feed rate is appropriate: if the spark does not spread and little, and condenses together, it means that the speed is too slow. If the spark spreads from top to bottom, it indicates that the cutting speed is appropriate; if the spark is inclined backward, it indicates that the feed rate is too fast, and some adjustments can be made.

Link to this article:What effect does the setting of the high speed fiber laser cutting machine have on the cutting processing effect

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.:Cut Wiki,Thanks!^^


Bookmark the permalink.

Comments are closed.