With the development of the times faster and faster, there are many mechanical devices that were not available in the society. This represents the increasingly high-tech of the times. Recently, the precision machining in the factory has been updated. What do you need to pay attention to during the cnc machining processing?
1. CNC machining :(1) When the workpiece is too high, it should be layered with different lengths of knife to open the thick, after using the large knife to open the thick, the remaining material should be removed with a knife.(2) Apply a flat-bottom knives machining plane, use less ball knives to reduce machining time; if there is a slope, and is an integer, apply a slanting knife.(3) Reasonably set the tolerance, so that the machining accuracy and the computer calculation time are balanced with each other, and more processes are performed to reduce the emptying time.(4) The hardness of the blank material is high, and the back milling is selected; the hardness of the blank material is low, and the down milling is selected. Roughing up-cut milling, finishing down-milling.(5) The tool material has good toughness, low hardness and is suitable for rough machining. The tool material has poor toughness and high hardness and is suitable for finishing. 2. CNC machining process technologies :(1) part clamping method and fixture selectionThe clamping method of the machined parts on the machining of cnc machine tools should also choose the positioning reference and clamping scheme reasonably. In the selection of fine reference, the two principles of “baseline uniformity” and “reference coincidence” should generally be followed. Principles, we have to consider: a. Try to finish all the surface processing in one positioning and clamping. Therefore, choose the positioning method that can make each surface can be processed. b. When the workpiece is clamped once, it should be able to finish processing all surfaces of the workpiece. c. When determining the placement position of the workpiece on the workbench, consideration should be given to the ability to take into account the machining of each station, the length of the tool and the stiffness of the tool on the machining quality. d. Fixtures used in controlled machining should be selected as much as possible, and adjustable clamps can be used to shorten the production preparation cycle. (2) Arrangement of processing sequenceWhen arranging the processing sequence, the basic principles must be observed, including "first face back hole”, “first rough and then fine”, etc. In addition to these basic principles, we should also follow the following principles: a. According to the tool centralized process, avoid the same tools repeated multiple times, reducing the number of times and time. b. The hole system with high coaxiality requirement should be processed after the positioning of the hole system after one positioning, and then the hole system of other coordinate positions can be processed, which can eliminate the error caused by repeated positioning and improve The coaxiality of the hole system. c. Choose to determine the good tool point and tool change point. Once it is determined, it should not be replaced.
For more detailed information, Welcome to check the website : www.ptjmachining.comPrevious: What factors in precision CNC machining will cause deformation of the workpiece ?Next: Benchmarking questions in precision CNC machining manufacturing
Link to this article：What should we pay more attention during manufacturing precision CNC machining ?
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki，Thanks